Tags

, , , , , , ,

oak

Green leaves picked September 11th. Dried some, frozen some, to dye on silk, cotton and a sample strip wool only. The rest dyed immediately. Test also early summer leaves 2014 as well as brown self-dried.

4:1 fresh, 2:1 dry – oak galls 2% if colour not strong.

Those are my notes in short form. 😉 What that means is, I’ve dyed some wool 4:1 ratio, with and without premordant, and same with an iron afterbath. Then I did it again with oak galls in there too. You don’t quite see it in the photo below, but the dark skeins are actually a deep, chocolate brown, and the ones with iron minus oak galls are greenish.

oak01

The oak galls don’t appear to do much to the oak colour itself, it works with the iron. Don’t leave your yarn in there too long unless you are aiming for black!!! Half an hour the old books say. First dye for an hour, add iron, simmer another half.

Technically people use oak to get grey, a wonderful smoky/silver shade. I got all sorts of brown and grey shades, but not that one!

So I’ve saved a few leaves in the freezer as well as dried some to test later. Perhaps the grey is more easily obtained on cotton?

cotton

cotton

Then I had a stroke of genious if I may say so. Especially since I had not bothered to actually check what other people do, I just followed the book. What if I did NOT dye the yarn first, but plunked it into the iron/oakgall/leaf bath when it was squeaky clean?!

oak04

But I’m kinda glad I did follow instructions first, or I would never have gotten all those other shades. Of course now I’m wondering what happens if you just use iron and oak galls…..

Oh – and if you rinse and rinse and the water still comes out black as night – make sure you don’t have a piece of oak gall trapped in your fiber. 😉

Egebladedanish

De gamle bøger siger: egeblade vægt 4:1 friske, 2:1 tørrede. 2% galæble for at få mørkere farve.

Så det prøvede jeg. Man skal passe på ikke at lade det ligge i gryden for længe efter tilsat jern, med mindre man går efter sort, en halv time er vist passende.

Galæblerne gjorde ikke rigtig noget ved selve farven, de virker først sammen med jern, her var der en tydelig forskel på de “grå” nuancer jeg fik. Måske de flotte sølvgrå jeg har set, har været på bomuld? Indtil det faldt mig ind at IKKE gøre som i bogen, nemlig farve i blade først, og så putte jern i til sidst. Og det virkede. Men jeg er da ret glad for, at jeg ikke checkede hvordan andre gør, for så havde jeg jo aldrig fået alle de fine brune!

Jeg farvede både ubejdset (det er det, de fleste bruger) samt alun- og kobberbejdset, her var også klar forskel, så man kan let skabe sig en gradueret skala til brug ved flerfarvearbejde.

oak on silk

Silk

 

Advertisements